High-quality axle for converting the wheel bearing assembly of the front spoked rim from open-shoulder ball bearings to sealed industrial deep-groove ball bearings on mopeds equipped with a Sachs V 905 wheel hub.
The two low nuts on the speedometer side are already pre-assembled in their fixed positions. This ensures the necessary clearance and eliminates the need for time-consuming spacing adjustments.
The colored markings show you where to install each part:
- green mark: brake anchor plate
- yellow mark: Replacement washer for the speedometer drive (the washer is not needed if a drive is installed)
- red mark: wheel hub or ball bearing conversion kit
- blue mark: fork legs
Note: This set includes all necessary washers, nuts, and spacer sleeves for the wheel axle. The additional set required for the spoked hub—including bearing shell adapters, SKF ball bearings, and a spacer sleeve—can be found separately in the accessories section.
A sophisticated product from the swiing® quality brand, designed to meet the highest standards.
| Thread type | MF11x1 (fine pitch thread) |
| Manufacturer | swiing® ingenious parts |
| Material | Steel, Chrome steel (colloquially known as stainless steel) |
| Surface | galvanized (blue) |
| Ø shaft | 11 mm |
| Total length | 150 mm |
| Universal |
| Sachs |
Accessories & related products
swiing® revival wheel axle set V905 wheel hub front | Sachs
Manufacturer: swiing® revival parts · Material: Chrome steel (colloquially known as stainless steel) · Material: Steel · Surface: galvanized (blue) · Diameter: 11 mm · Total length: 145 mm · Ø ball [inch] / [mm]: 1/4" (6.35 mm) · Thread type: MF11x1 (fine pitch thread) · Ø shaft: 11 mm · Ball bearing closed: No · Width across flats: 17 mm
EUR 41.40
Not in stock
Explore categories from Hub & axle
Moped fans also bought
swiing® revival Ball Holder 25/37/6.3 Kickbike
Bearing cage: Sheet steel cage ball-guided · Stock number: K042 · Inner ring width: 25 mm · Ball bearing closed: No · Manufacturer: swiing® revival parts · Ø ball: 6.34 mm · Groove ring: No · Material: Steel · Ø inside: 25 mm · Bearing type: Ball ring · Ø outside: 36 mm · Width: 6.8 mm · Area of application: Standard
EUR 9.40
swiing® ingenious assembly tool clasp brake shoe
Manufacturer: swiing® ingenious parts · Area of application: Special tool · Material: Steel · Surface: galvanized (blue) · Number of components: 3 pcs · Total length: 41.1 - 65 mm · Ø outside: 10 mm · Thread type: M6x1 (standard thread) · Thread length: 30 mm · Width across flats: 8 mm
EUR 19.60
GPO speedometer drive 17" with hook 11 mm axle (for VDO speedometer cable)
Manufacturer: GPO · Place of use: left · Place of use: right · Ø axle: 11 mm · Material: Aluminum · Ø outside: 41 mm · Wheel size: 17 " · 4-edge speedometer cable: 1.8 mm · 4-edge speedometer cable: 2.6 mm · Thread type: MF10x1 (fine pitch thread) · Ø mounting hole: 11 mm
EUR 33.10
Working late? Evening hours on Thursday until 20:00
